How to Replace a Toilet Tank Flush Lever

Replacing a toilet tank flush lever is a simple task that can be done in a few easy steps. Here's how to do it:

Step 1: Turn off the water supply
The first step in replacing a toilet tank flush lever is to turn off the water supply to the toilet. Locate the shutoff valve behind the toilet and turn it clockwise until it stops. Flush the toilet to drain the water from the tank.

Step 2: Remove the old flush lever
Locate the flush lever on the side of the toilet tank and remove the mounting nut that secures it. You may need to use pliers or a wrench to loosen the nut. Once the nut is removed, pull the old flush lever out of the tank.

Step 3: Install the new flush lever
Insert the new flush lever into the hole in the tank and secure it with the mounting nut. Tighten the nut with pliers or a wrench, but be careful not to overtighten it as this can cause damage to the tank.

Step 4: Attach the chain
Attach the chain from the new flush lever to the flapper valve in the bottom of the tank. Adjust the chain so that it has just enough slack to allow the flapper valve to close properly.

Step 5: Turn on the water supply
Turn the shutoff valve behind the toilet counterclockwise to turn the water supply back on. Allow the tank to fill with water and test the new flush lever to make sure it is working properly.

Replacing a toilet tank flush lever is a quick and easy task that can be done in just a few minutes. With these simple steps, you can have your toilet functioning properly again in no time.